Manual cleaning

Our complex solution

Manual PCB cleaning

Flux Remover 4

technical data sheet

Manual PCB cleaning after the reflow process.

Special bristles

with optimal hardness, developed especially for PCB cleaning. Thanks to the unique material of the fibres, they do not fray and their working life is extended.

High evaporation

the remaining fluids will quickly evaporate and the board stays completely dry

Flux Remover 4
Are you interested in testing the Flux Remover 4?

Manual cleaning of reflow oven

Manual stencil cleaning

Trends that raise demands on cleanliness in the pick-and-place process

  • The general miniaturisation of PCB
  • The reduction of operating voltage
  • Narrower and smaller component spacing
  • Shorter distances between conducting paths
  • The rise in the use of electronics in all areas of industry

Why should you clean by hand?

PCBs

Manual cleaning is used for repairs to PCBs and for final cleaning during the process. This is the only way of cleaning PCBs that can not be put into a cleaning device.

Reflow ovens and waves

Used for regular upkeep to ensure that technology is fully functional. This is the only way of cleaning components and parts that cannot be dismantled and put into a cleaning device.

Subscribe to the DCT mailing list and get the latest news.

All fields are required

Please, choose Your title
First name cannot be blank
Last name cannot be blank.
Your E-mail Adress is not a valid email address.
Company cannot be blank.
Work position cannot be blank.
Country cannot be blank.
eu

Privacy Policy | download

Copyright © 2015 DCT Czech s.r.o. All rights reserved.

Created by Ondřej Vašíček